Page 1 of 1

ESX1 pattern quantize launch

PostPosted: Thu May 25, 2017 4:42 am
by gigid
Hello

I'm trying to use this setting:

-Yamaha RM1x as sequencer (master)

-Korg ESX1 (slave)


when I change session on the Yamaha, I set a program change so that the Korg change pattern.

The problem is that the Korg receive the message, change the pattern but it takes one bar to start the new pattern.

This makes my performance impossible to be good as you can imagine,

any help?

thanks

Gigi

ps

the Yamaha allow me to se the pattern quantize to 1 or 1/16 quarter