Problem: Spontaneosly changing parameters

Ask and discuss about how to work with electribes. Share your discoveries and ideas.

Moderator: Aciphecs

Problem: Spontaneosly changing parameters

Postby OSCILLATOR2 on Sat Dec 02, 2017 12:13 pm

I've had really good time with my EMX-1 for 5 months now. Unfortunately, I was having a live performance and after that there has been some annoying problems with my gear.
Basically, the EMX-changes parameters (cutoff, eg time, resonance) spontaneosly. It doesn't happen every time and rebooting once or twice helps. However, I'd really liked to try to fix this problem. I do not understand the hardware in EMX so well, could it be that some solder joint has disconnected?

I take my EMX to guy who knows a lot about radio electronics, but do you have some hints to troubleshooting?

Best regards,
Electribe Newbie
Posts: 1
Joined: Sat Dec 02, 2017 11:31 am

Re: Problem: Spontaneosly changing parameters

Postby Almra on Sun Jul 15, 2018 3:10 pm

I have The same problemas, with eg time... No way to solve.. I cleaned The knobs and helped a bit bit comes. Black once IN a while. I temporaly solve The issue by tweaking The knob gone wild, applying The changes to a fandom and unused part
User avatar
Electribe Newbie
Posts: 41
Joined: Sun Apr 12, 2015 7:26 am
Location: Tenerife, Spain

Re: Problem: Spontaneosly changing parameters

Postby The oscillator on Mon Sep 17, 2018 3:40 pm

I fixed this by disconnecting and reconnecting the ribbon cable from the arp to the lower board . Make sure every thing is seated well and the keeper is pushed up tight
The oscillator
Electribe Newbie
Posts: 2
Joined: Sun Sep 16, 2018 5:24 pm

Return to Technical Talk

Who is online

Users browsing this forum: No registered users and 2 guests